• 2 Confetti Cannons
• 2 100-Ft. Spools of Wire
• 1 2-Zone Control Box with 12-Volt Sealed Battery
• 1 Control Box Battery Charger
• 1 Cannon Helium/Nitrogen Recharge Hose
• 1 Heavy Duty Carrying Case.

Easy to Charge!
The Cannon Recharge Hose enables user to recharge cannon with helium or nitrogen gas from a cylinder with a minimum pressure of 1200 PSI. The Recharge Hose Regulator is preset to automatically fill the cannon to the proper pressure.


Easy to Load!
Screw the barrel on to the cannon. Remove the cap ring from the barrel and fill the barrel with confetti. If using bundled confetti, be sure to remove the rubber bands before placing them in the barrel. Place a 6-inch round piece of foil balloon over the barrel and screw on the locking cap. When the cannon is fired the confetti will burst through the foil seal making a loud popping sound that adds to the excitement!


Easy to Rig!
The rigging mount, located at the bottom of the barrel, fits a 1/2" electrical conduit. Place the conduit into the mount and firmly tighten the set screw to secure the cannon in place. The angle of the cannon barrel can be adjusted to achieve different effects. Cannons can be rigged up to 100-feet away from detonator box.


Easy to Fire!
On cue, push and hold down the Control Box detonator button until the cannon has completely fired. For best results, wait for approximately 2 seconds between pressing the first and second button. This will prolong the air time of the confetti.